Getting a static IP address if pinging is unsuccessful
If you ping an address and the address does not respond, you can use the
ipconfig /all command to determine the correct IP address.
To get an IP address if the ping is unsuccessful
-
On the computer that contains the recovery point that you want to restore, at a DOS prompt, type the following command, and then press Enter.
ipconfig /all -
Write down the IP address that is displayed.
Return to the computer that is running the Arctera System Recovery Disk environment.
-
In the Network panel of the Arctera System Recovery Disk environment, click Ping a Remote Computer and use the IP address you wrote down.